Hydraulic Hose Flow Rate Chart

Hydraulic Hose Flow Rate Chart – Flow rate (gpm) * hose length (feet) * fluid properties specific gravity (g/ml) * viscosity (cp) * for unknown specific gravity or viscosity reference to viscosity data. The chart below is designed and provided as an aid in the determination of the correct hose size. Gallons per minute, what is proper hose. Gallons per minute for a hose:

Use this nomograph to select the correct hose id size, flow rate and flow velocity for your hydraulic applications. For water, water/glycol, and water/oil emulsion hydraulic fluids the maximum working temperature drops to +185°f and for air, the rating drops to +158°f. The following velocity charts are a quick way to check velocity through a line. To use the nomogram, draw a straight line across the entire nomogram, intersecting the.

These are maximum recommended flow rates, and this chart is based on a maximum acceptable pressure drop of 15% per 100 feet of hose. Place a straightedge along a line from the flow rate. Adequate sizing of hydraulic hoses is an essential step of any project.

Velocity, based on flow (q) and hose id, or flow (q) based on velocity and hose id. Use a straight edge to connect the flow rate that your. Flow rate is the volume of hydraulic fluid produced by the hydraulic pump over a specific amount of time and is commonly measured using gallons per minuteor gpm.

Flow rate of 3/8 tubing: Where pressure drop must be. This chart is used to determine the size of hose needed to fill flow rate and velocity requirements.

Flow capacities of hose assemblies at suggested flow velocities. It depends on the hose size and pressure, but typical garden. A = square inch inside area of conductor.

Flow and Velocity Kurt Hydraulics